Radius MultiView 24
@8066.adf  Radius Multiview 24 (NOT SVGA Multiview!) 
MV24DISK.ZIP  Multiview 24 installation disk 
Radius_MV24 My archive...
WD95C00-SET1 Datasheet
Bt473 Datasheet
MT42C8255DJ -8 Datasheet

Multiview 24
ADF Sections

Radius MultiView 24

P1 Solder pads for 100 pin header 
P2 Solder pads for 44 pin header 
P4 25 pin video pass through 
U8 WDC WD95C00-MR 
U9-U20 256Kx4 DRAM MT42C8255DJ -8
U24 Brooktree Bt473KPJ80 RAMDAC 
U32 Altera 
U35-U37 WDC WD95C01-LR 
X1 14.3181 MHz Crystal

Win95 and NT
   The MultiView 24 board will not be updated beyond this driver version, nor will it be supported under Windows 95 or Windows NT.  Windows 95 expects a user-accessible base MMIO address, and since the MultiView 24 board pre-dates these requirements by several years and offers no MMIO interface, it will not be possible to retrofit or upgrade it to run under Windows 95.

   MV24SET.EXE is the setup program for the MultiView 24.  It must be run in order to enable the ROM and select its address, and to select a monitor type and appropriate refresh rates.  MV24SET will be run automatically the first time INSTALL is run on a new MultiView 24.  If you wish to change your ROM address or monitor type or refresh rate after the first time installation to your hard disk, run MV24set.exe 

   MV24INIT.EXE is an optional substitute for the on-board ROM.  It performs the same initialization as the ROM does on power-up.  This program should only be installed if MV24SET has been run and it has been determined that the on-board ROM must be disabled due to unresolveable address conflicts. If MV24INIT is used to replace the ROM, it must be run every time the system is booted, preferably as part of the AUTOEXEC.BAT.  The INSTALL utility will automatically add MV24INIT to your AUTOEXEC.BAT file if you so choose.  To install MV24INIT, run INSTALL from the Utilities and Drivers disk, select MV24INIT, and complete the installation according to the on-screen instructions. 

   CLR24.EXE is a screen clearing utility for the MultiView 24 when it is used in a dual-screen configuration (VGA and MultiView 24 connected to separate monitors).  If an application leaves a graphics image on the MultiView 24 screen after exiting, CLR24.EXE can be run to clear the image from the MultiView 24 screen.  To run this utility after installation to your hard disk, run CLR24.exe

   FPP1024.EXE is a utility for 1024x768 modes when the MultiView 24 is connected to a Radius Full Page Pivot display.

AdapterId 8066 Radius MultiView 24 MC

Card Enable
   This allows you to disable the Radius MultiView 24 card. 
  <Enabled>, Disabled 

EPROM Enable
   This allows you to disable the EPROM of the card.  This is useful only if other adapters conflict with the MultiView 24." 
  <Enabled>, Disabled" 
 Note that if you have disabled the ROM, you must run MV24INIT.EXE, which is the RAM replacement for the ROM, every time you boot your system. 

9595 Main Page